ολα τα λογισμικα του xtrend (και αυτα που αναφερεις ως original) ειναι φτιαγμενα απο την pli. η διαφορα ειναι οτι εκεινο ειναι σε kernel 2.6.xx.φιλε μου,ειχα ομοιο προβλημα με εσενα με ολα τα λογισμικα 3.χ.χ και μετα.καποιος ecki μου απαντησει σε καποιο ξενο φορ*ουμ το εξης
Code:
Hi, i had a similar problem with Seagate ST500DM002. Neither the hdd itself nor the SATA controller had a defect, but OpenPLi (version from early January) did not detect the device. The last chance was to try downgrading the SATA 6G ("SATA 3") interface by using a jumper (resulting in SATA (1) mode). Finally, the hdd was detected correctly, automatically ext4 formatted. Seems ok now. The correct jumper settings should be present on the Seagate support site. Hope this helps!
The BC7413 built in SATA controller does not support third generation SATA interfaces and obviously there is a problem in using slower modes for that kind of devices (at least for somer of them).
Greetings from Germany, Ecki
η λυση ηταν ενα jumperακι στον δισκο που τον κανει να δουλευει σε 1.5Gb/s (κατι που μου ειχαν προτεινει νωριτερα να δοκιμασω και τα παιδια της δικης μας ομαδας!) οπως αυτο που ειναι στην φωτο .δοκιμασε το και πες μας το αποτελεσμα!