Results 1 to 6 of 6

Thread: Some issues with Edision Mio 4K

  1. #1
    stpierre's Avatar
    Join Date
    Feb 2017
    Location
    Belgium
    Posts
    114
    Rep Power
    0

    Some issues with Edision Mio 4K

    Hello,

    I use "SatDreamGr Images 6" with Edision Mio 4K.

    In Usals mode after a restart, the last location in infobar show always 28.2 east.

    The sound volume is very low on all the channels by comparison with other box.

    Some channels with lower signal(under 20dB) in DVB-T "freeze", but with the same antenna and an other E2 box they works fine.
    This issue appear only with 64 QAM modulation, in 16 QAM no problem with low signal.
    Attached Images Attached Images
    Last edited by stpierre; 22-01-19 at 16:17.
    TBS5520SE > Fibo 90cm USALS = 68°e > 45°w
    Octagon SF4008 & Edision Mio 4K
    Multisat Indoor Home Made 10 LNB 52°e > 5°w
    Fibo 90cm USALS = 68°e > 45°w

  2. #2

    athoik's Avatar
    Join Date
    Sep 2012
    Location
    Earth
    Posts
    10,758
    Rep Power
    5927763

    Απ: Some issues with Edision Mio 4K

    The issue with low sound is reported already!

    The DVB-T issue reported.

    No idea about USALS.
    Member SatDreamGr Projects

    Wavefield T90: 0.8W - 1.9E - 4.8E - 13E - 16E - 19.2E - 23E - 26E - 33E - 39E - 42E - 45E on EMP Centauri DiseqC 16/1
    Unamed: 13E Quattro - 9E Quattro on IKUSI MS-0916

  3. #3
    stpierre's Avatar
    Join Date
    Feb 2017
    Location
    Belgium
    Posts
    114
    Rep Power
    0

    Re: Some issues with Edision Mio 4K

    Hello,

    Same issues after the last update.

    In DVB-T what do you think about the screennshot, it's not a current picture with low signal!
    Maybe this issue seems to be a defective demodulation?
    Thanks or reply.
    Attached Images Attached Images
    TBS5520SE > Fibo 90cm USALS = 68°e > 45°w
    Octagon SF4008 & Edision Mio 4K
    Multisat Indoor Home Made 10 LNB 52°e > 5°w
    Fibo 90cm USALS = 68°e > 45°w

  4. #4

    athoik's Avatar
    Join Date
    Sep 2012
    Location
    Earth
    Posts
    10,758
    Rep Power
    5927763

    Απ: Some issues with Edision Mio 4K

    Can you please update again, some commits reverted lately in OpenPLi, maybe those caused that issue.

    Although signal is low (usually I have way more dB on my DVB-T).

    Ok, some receivers have better reception, but just changing a cable or putting better antenna or ... can give more dB.

    I used to have also the same problem with a USB tuner that was making pixelation.

    My house had a cheap no name FM-SAT socket.

    I changed it to this one: https://www.hellasdigital.gr/tv-and-...226-tv-fm-sat/

    I gain more than 1dB and pixelation on usb tuner gone away!
    Member SatDreamGr Projects

    Wavefield T90: 0.8W - 1.9E - 4.8E - 13E - 16E - 19.2E - 23E - 26E - 33E - 39E - 42E - 45E on EMP Centauri DiseqC 16/1
    Unamed: 13E Quattro - 9E Quattro on IKUSI MS-0916

  5. #5
    stpierre's Avatar
    Join Date
    Feb 2017
    Location
    Belgium
    Posts
    114
    Rep Power
    0

    Re: Some issues with Edision Mio 4K

    Thanks Athoik for those suggestions.

    Update done today, maybe a little improvement but no sufficient.
    I have this issue only on channel 30 (554 Mhz) but the reception is ok with my other E2 box (still tested today with same cable, the two box are side by side) on this frequency, no problem all the time since a few years!

    Antenna is a Kathrein AOS32 length 3.85m , the best (I think) for receive channels from 21 to 32.
    This one is directly connected to the box, no amplifier, splitter, loop throught etc, with 11m cable 17 VATC.
    With this install, no issues in DVB-T since the start of DVB-T in France, and with E2 box since 2014.
    Maybe other updates can resolve this issue...or my box is defect?

    Off topic, but I would like to say that this box is very good, very sensitive in DVB-S.
    Blind scan work like a charme in transpondeurs in MIS PLS and MIS PLP T2-MI...etc
    My TBS card can't do that!

    Best Regards
    TBS5520SE > Fibo 90cm USALS = 68°e > 45°w
    Octagon SF4008 & Edision Mio 4K
    Multisat Indoor Home Made 10 LNB 52°e > 5°w
    Fibo 90cm USALS = 68°e > 45°w

  6. #6

    athoik's Avatar
    Join Date
    Sep 2012
    Location
    Earth
    Posts
    10,758
    Rep Power
    5927763

    Απ: Some issues with Edision Mio 4K

    It might be possible that tuner has an issue.

    I also had this with one manufacturer!

    So you might need to provide the full details to Edision support.
    Member SatDreamGr Projects

    Wavefield T90: 0.8W - 1.9E - 4.8E - 13E - 16E - 19.2E - 23E - 26E - 33E - 39E - 42E - 45E on EMP Centauri DiseqC 16/1
    Unamed: 13E Quattro - 9E Quattro on IKUSI MS-0916

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Edision os mio 4k προσαρτηση nas
    By th3m1s in forum Περί Edision Enigma 2
    Replies: 2
    Last Post: 05-06-19, 22:04
  2. Edision OS MIO 4K
    By johnw in forum General Forum Edision Receivers
    Replies: 0
    Last Post: 13-12-18, 14:30
  3. T2MI on 4,8°east:issues!
    By ettore88 in forum English Section General
    Replies: 0
    Last Post: 20-01-18, 22:06

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •