Problems with Hauppauge driver

[eastof111]

"So on cold boot the device is not displayed on tuner list?"

No, it is not displayed. It will display after doing an enigma restart.

[elbandido]

Per Chance, Did you have the Sundtek ATSC device installed and running at one point with the image you are using now?

[eastof111]

Originally, I still had the Sundtek control center displayed in the plugins menu, but not in the systems menu. I did remove the S99tuner.sh file from /etc/rc3.d to disassociate any reference to the Sundtek tuner. But, still the Hauppauge driver would not recognize the usb tuner.

Then did a new install via usb stick of Satdreamgr into flash and did not restore any settings. After installing Hauppauge driver, it still did not recognize the usb tuner. Had to do the opkg install routine, then enigma restart and the tuner was displayed.

Tomorrow, with time and access to the receiver, I will do a clean install again via usb stick of Satdreamgr without restoring settings. Then:
1- install Hauppauge driver.
2- shut down receiver.
3- cold reboot.
4- if usb tuner is displayed, will continue to scan channels.... if not displayed will do enigma start.
5- if usb tuner is displayed, will continue to scan channels.... if not displayed will do the opkg install routine and hopefully a solution is found later.

[eastof111]

Installed Satdreamgr-4.0-gst1-vuduo2-20161106 using usb stick. Next, searched directories for any reference of Sundtek using Filezilla (none). Then, proceeded to do steps 1 through 5 as listed in post #13.

Final results are the same as before. The Hauppauge driver does not recognize the usb tuner. Upon a cold reboot, the enigma restart must be used in order for the usb tuner to be recognized. Other than that, the usb tuner is working flawlessly.

Even though there are hiccups with the driver (?), I am very grateful the usb tuner works for my location.

[athoik]

Without having access to the same hardware it's hard, and logs didn't shown the cause.

Maybe we can arrange a remote session to inspect box, send me a pm during the weekend.