How to setup Crossepg {XEPGDB providers} on a USB stick

How to setup Crossepg {XEPGDB providers} on a USB stick

As follows:-

1} Press Menu on your STB Remote Control and choose SETUP {1}

http://www.vuplus-community.net/boar...ts/1-jpg.9671/

2} Then select CrossEPG {2}

http://www.vuplus-community.net/boar...ts/2-jpg.9672/

3} Press Configure and in this menu you will setup the location to store the EPG data.
The best place is on a USB stick, because it is fast. You should see a menu similar to this {3}

http://www.vuplus-community.net/boar...ts/3-jpg.9673/

4} Now Press the RED button to save and you will go back to the CrossEPG main menu.
Next you must Update XEPGDB Providers, the info page will look like this {4}

http://www.vuplus-community.net/boar...ts/4-jpg.9674/

5} Now your provider list has been updated, so now select XEPGDB providers {5}

http://www.vuplus-community.net/boar...ts/5-jpg.9675/

6} In the XEPGDB providers menu, just select the provider(s) that you want to download,
the info page will look like this {6}

http://www.vuplus-community.net/boar...ts/6-jpg.9676/

7} Now press the Yellow button to download the 3 providers that were selected.
*On the first generation boxes (Solo, Duo, Uno and Ultimo), it is a good idea to only select 2 or 3 providers as the epg data fills up the memory very quickly*. On the Solo2 you can select all packages without any issues. {7}

http://www.vuplus-community.net/boar...ts/7-jpg.9677/

8} Now your EPG is ready to used {8}

http://www.vuplus-community.net/boar...ts/8-jpg.9678/

9} To update your EPG data, you can either navigatie into the main CrossEPG menu, and select Download now, or you can Press the Green button @STB Remote Control and use the CrossEPG Downloader. {9}

http://www.vuplus-community.net/boar...ts/9-jpg.9679/

9.1} After Pressing CrossEPG Downloader the data will be download, converted and then loaded ready for use automatically. {9.1}

http://www.vuplus-community.net/boar.../9-1-jpg.9680/

*** The above guide can also be used for the Rytec EPG packages, just select Rytec instead of XEPGDB and follow the above guide ***

Thank you EVO, Artorius, bogdanm and vuplus-community.net