Transcoding on Solo 2

[devilcosta]

openwebif by your web browser

Settings/Transcoding Setup

[Robinson]

Well, thanks, devilcosta.
What does "streamproxy -f" show if you set the port back to 8002? Does it give the same network error as in my case?

ClientSocket: trap: WebifRequest: cannot connect (std::exception), system error: Network is unreachable

If so, there still seems to be a bug somewhere in Transcoding for Solo 2.

[Robinson]

Also, I have a suspicion transcoding through 8001 is really streaming without any transcoding going on.
devilcosta, if you run transcoding through 8001, what resolution and bitrate do you get? Aren't they the same as the original transport stream?
Thanks.

[devilcosta]

I think you're right

[Robinson]

So, athoik, we can safely assume it does not work on Solo 2.

[georgeflu]

So, athoik, we can safely assume it does not work on Solo 2.

no,because we found another solo2 which works. there is something missing in your receiver/image (maybe something wrong in an upgrade...) we are looking about this.

[athoik]

Yes, there is an error (network one), maybe install tcpdump in order to figure where it tries to connect!

Or maybe add more debug messages to streamproxy, network error is too generic!

[athoik]

Yes, there is an error (network one), maybe install tcpdump in order to figure where it tries to connect!

Or maybe add more debug messages to streamproxy, network error is too generic!

[Robinson]

Yes, there is an error (network one), maybe install tcpdump in order to figure where it tries to connect!
Or maybe add more debug messages to streamproxy, network error is too generic!

Hi athoik,
Is this suggestion for me?
How to test the connection with tcpdump? What would the commands be?
And how can I debug streamproxy in a more detailed way, please?

[athoik]

No this is something we need to figure out.

We have confirmed that something is wrong so we will trace the issue.

So please patience.